Cisco Cisco ASR 5000
GGSN Service Configuration Mode Commands
▀ authorize-with-hss
▄ Command Line Interface Reference, StarOS Release 18
5216
authorize-with-hss
This command enables or disables subscriber session authorization via a Home Subscriber Server (HSS) over an S6b
Diameter interface. This feature is required to support the interworking of GGSN with P-GW and HA.
Diameter interface. This feature is required to support the interworking of GGSN with P-GW and HA.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > GGSN Service Configuration
configure > context context_name > ggsn-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ggsn-service)#
Syntax
authorize-with-hss [ report-ipv6-addr ]
{ default | no } authorize-with-hss
default
Disables the default authorization of subscriber over S6b interface. Resets the command to the default setting
of “authorize locally” from an internal APN authorization configuration.
of “authorize locally” from an internal APN authorization configuration.
no
Disables the default authorization of subscriber over S6b interface. Resets the command to the default setting
of “authorize locally” from an internal APN authorization configuration.
of “authorize locally” from an internal APN authorization configuration.
report-ipv6-addr
Enables IPv6 address reporting through Authorization-Authentication-Request (AAR) towards the S6b
interface.
interface.
Usage
Use this command to enable/disable the authorization support for subscriber over S6b interface, which is used
between GGSN and the 3GPP AAA to exchange the information related to charging, P-CSCF discovery, etc.
Use of this feature allows the GGSN service to interact with HSS over S6b interface through Diameter
configuration which is already configured on the system.
between GGSN and the 3GPP AAA to exchange the information related to charging, P-CSCF discovery, etc.
Use of this feature allows the GGSN service to interact with HSS over S6b interface through Diameter
configuration which is already configured on the system.
Important:
Diameter configuration must be available before enabling this command. For more information
regarding Diameter interface configuration, refer Diameter Endpoint Configuration Mode Commands chapter.
Important:
This command is a license-enabled feature.