Cisco Cisco Packet Data Gateway (PDG)
HNB-GW Global Configuration Mode Commands
▀ paging open-hnb
▄ Command Line Interface Reference, StarOS Release 18
6434
paging open-hnb
Configures paging optimization parameters for open HNBs connected through Hybrid Access mode in the HNB-GW
Global parameter.
Global parameter.
Important:
This command is deprecated from release 16.0.
Product
HNB-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > HNB-GW Global Configuration
configure > hnbgw-global
Entering the above command sequence results in the following prompt:
[local]host_name(config-hnggw-global)#
Syntax
paging open-hnb [hnb-where-ue-registered fallback] {always | never | only-if-with-paging-
area}
area}
default paging open-hnb
default
Sets the default behavior of paging optimization configuration for an open HNB while using Open Access
mode support.
By default the HNB-GW pages open HNBs only if paging-area IE is received in the paging message.
mode support.
By default the HNB-GW pages open HNBs only if paging-area IE is received in the paging message.
{always | never | only-if-with-paging-area}
Sets the HNB-GW Global configuration instance to page open HNB for a paging message.
always
: Sets the system to ALWAYS page the open HNBs irrespective of paging-area IE is received in
paging messages.
never
: Sets the system to NEVER page any open HNB.
only-if-with-paging-area
: Sets the system to page the open HNBs only when paging-area IE is
received in paging messages.
hnb-where-ue-registered fallback {always | never | only-if-with-paging-area}
Sets the HNB-GW Global configuration instance to page open HNB from where the UE is registered.
always
: Sets the system to ALWAYS page the open HNBs from where the UE is registered. If the UE is not
registered then it pages the open HNBs irrespective of paging-area IE is received in paging messages.
never
: Sets the system to page the open HNBs from where the UE is registered. If the UE is not registered
then it NEVER pages any open HNB.
only-if-with-paging-area
: Sets the system to ALWAYS page the open HNBs from where the UE is
registered. If the UE is not registered then it pages the open HNBs only when paging-area IE is received in
paging messages.
paging messages.