Cisco Cisco Packet Data Gateway (PDG)
RNC Configuration Mode Commands
▀ dual-address-pdp
▄ Command Line Interface Reference, StarOS Release 18
8254
"reactivation-required" to ensure the UE, RNC, SGSN, and GGSN are in synch. As well, this gives the UE
the opportunity to activate a PDP context again without dual bearers.
The
the opportunity to activate a PDP context again without dual bearers.
The
sgsn-rnc-no-dual-pdp-init-pdp-deact
disconnect reason is used to indicate that a PDP context
has been deactivated because of roaming into an RNC that does not support this feature.
Important:
For this configuration to function, support for dual PDP-type addressing must be enabled at the
global level (the default). To confirm the functionality is enabled, issue the
show sgsn-mode
command from the Exec
mode. If the PDP-type addressing is not enabled, then refer to the instructions for the
dual-address-pdp
command in
the SGSN Global Configuration Mode Commands section.
Example
Use the following command to enable dual PDP-type addressing with a supporting RNC:
dual-address-pdp supported