Cisco Cisco Packet Data Gateway (PDG)
SLs Service Configuration Mode Commands
t-3x01 ▀
Command Line Interface Reference, StarOS Release 18 ▄
8749
t-3x01
Configures timer settings for “low delay” and “delay tolerant” response times from the E-SMLC.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > SLs Service Configuration
configure > context context_name > sls-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sls-service)#
Syntax
t-3x01 low-delay seconds delay-tolerant seconds
default t-3x01
default
Resets the timer to the default setting of 20 seconds for both low delay and delay tolerant requests.
low-delay
Indicates the number of seconds within which the MME expects to receive a “low delay” response from the
E-SMLC, where fulfillment of the response time requirement takes precedence over fulfillment of the
accuracy requirement.
E-SMLC, where fulfillment of the response time requirement takes precedence over fulfillment of the
accuracy requirement.
seconds
must be an integer from 10 to 30. The default setting is 20 seconds.
delay-tolerant
Indicates the number of seconds within which MME expects to receive a “delay tolerant’ response from the
E-SMLC, where fulfillment of the accuracy requirement takes precedence over fulfillment of the response
time.
E-SMLC, where fulfillment of the accuracy requirement takes precedence over fulfillment of the response
time.
seconds
must be an integer from 10 to 40. The default setting is 20 seconds.
Usage
These timer options can be configured to prioritize location request response times from the E-SMLC. The T-
3x01 timer is started by the MME on sending a location-request to the E-SMLC, and is stopped when either
the requested is responded, aborted, or reset by either the MME or the E-SMLC.
A location procedure ends after the Delay Tolerant timer expires and no response is received from an E-
SMLC.
More details about these settings are available in 3GPP TS 22.071.
3x01 timer is started by the MME on sending a location-request to the E-SMLC, and is stopped when either
the requested is responded, aborted, or reset by either the MME or the E-SMLC.
A location procedure ends after the Delay Tolerant timer expires and no response is received from an E-
SMLC.
More details about these settings are available in 3GPP TS 22.071.
Example