Cisco Cisco Packet Data Interworking Function (PDIF)
PCC-Action-Set Configuration Mode Commands
▀ dynamic-rule-install
▄ Command Line Interface Reference, StarOS Release 18
7642
defer-by
interval
delayed_dur
This optional keyword supports the time-of-day-based procedures under PCC-Action-Set instance by
configuring the relative time delay for dynamic rule installation.
configuring the relative time delay for dynamic rule installation.
delayed_dur
configures the relative delay time by which the corresponding dynamic rule installation is
deferred. The action is triggered only when the time specified by
delayed_dur
is passed.
delayed_dur
specifies the delayed interval in
HH
MIN
SS
format.
Following format is used for
HH
MIN
SS
in
delayed_dur
:
HH
specifies the hour to defer the action trigger and must be an integer between 00 through 23.
MIN
specifies the minutes to defer the action trigger and must be an integer between 00 through 59.
SS
specifies the seconds to defer the action trigger and must be an integer between 00 through 59.
failure-policy
{
continue
|
terminate
}
Default: Continue
This optional keyword configures the rule failure policy action when failure occurs on PCEF for PCC rules.
This optional keyword configures the rule failure policy action when failure occurs on PCEF for PCC rules.
Continue: If this option enabled, the IPCF continues even if PCEF reports rule failure through charging
rule report. This is the default action.
Terminate: If this option enabled, the IPCF triggers PCC session termination on receiving rule failure
through charging rule report.
Usage
Use this command to set an action to install a PCC Dynamic rule for the specified PCC-Data-Service in PCC-
Action-Set configuration for PCC-Service instance
Operator can override parameters such as, QoS profile, Precedence, Gate-status, Monitoring Key and PCC-
Rating-id.
The same command is used to modify already installed PCC Dynamic-rule for the PCC-Data-Service by
overriding required parameters only.
Additionally
Action-Set configuration for PCC-Service instance
Operator can override parameters such as, QoS profile, Precedence, Gate-status, Monitoring Key and PCC-
Rating-id.
The same command is used to modify already installed PCC Dynamic-rule for the PCC-Data-Service by
overriding required parameters only.
Additionally
defer-by
interval
keyword is used to configure relative time by which the corresponding
dynamic rule installation is deferred.
IPCF handles operation of PCC Rule and activate/deactivate/install/modify/remove the PCC rules at PCEF
through this configuration. PCC rule operation may fail on PCEF due to various reasons. In such failure cases
PCEF sends back a Charging Rule Report containing name of the failed PCC rule and corresponding failure
cause.
The IPCF handles these charging rule report and take appropriate actions based on configuration done
through
IPCF handles operation of PCC Rule and activate/deactivate/install/modify/remove the PCC rules at PCEF
through this configuration. PCC rule operation may fail on PCEF due to various reasons. In such failure cases
PCEF sends back a Charging Rule Report containing name of the failed PCC rule and corresponding failure
cause.
The IPCF handles these charging rule report and take appropriate actions based on configuration done
through
failure-policy
keyword.
Charging Rule Report comes through CCA or RAA messages in a call flow used for handling the charging-
rule-report.
IPCF supports following charging rule failure codes in report:
rule-report.
IPCF supports following charging rule failure codes in report:
Out-of-credit
Reallocation-of-credit
Unknown rule name
Invalid Rating Group
Invalid Service Identifier
GW/PCEF Malfunction