Cisco Cisco ASR 5700
Call Control Profile Configuration Mode
rfsp-override ue-settings ▀
Command Line Interface Reference, StarOS Release 17 ▄
2069
new-val value
Assign a new RFSP Index value.
value
: Enter an integer from 1 to 256.
Multiple UE value/new value combinations can be configured in a single command.
Usage
Use this command to assign an RFSP Index for a UE based on the following factors:
Operator policy (where IMSI range or PLMN can influence the selected RFSP)
UE usage setting (voice centric, data centric)
Voice domain preference (CS voice only, CS voice preferred, IMS PS voice preferred, IMS PS voice
only).
To support Radio Resource Management (RRM) in E-UTRAN, the MME provides the parameter RFSP
Index to an eNodeB across S1. The RFSP Index is used by the eNodeB to apply specific RRM strategies.
The MME receives the subscribed RFSP Index from the HSS, then overrides the RFSP Index for the UE
based on the settings defined in this command.
Multiple UE value/new value combinations can be configured.
Index to an eNodeB across S1. The RFSP Index is used by the eNodeB to apply specific RRM strategies.
The MME receives the subscribed RFSP Index from the HSS, then overrides the RFSP Index for the UE
based on the settings defined in this command.
Multiple UE value/new value combinations can be configured.
Example
The following command overrides the RFSP Index value for voice-centric circuit switched calls to an RFSP
Index of 10:
Index of 10:
rfsp-override ue-setting voice-centric voice-domain-pref cs-voice_only
new-val 10
new-val 10