Cisco Cisco Packet Data Gateway (PDG)
Context Configuration Mode Commands I-M
ip rri-route ▀
Command Line Interface Reference, StarOS Release 17 ▄
2555
ip rri-route
Configures High Availability (HA) IPv4 routing parameters for Reverse Route Injection (RRI). (VPC-VSM only)
Product
SecGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration
configure > context context_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-ctx)#
Syntax
ip rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip virtual_ip_address } {
ip_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
ip_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
no ip rri-route network-mode { L2 | L3 } { clear_loopback_ip | rri-ip virtual_ip_address
} { ip_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
} { ip_address | next-hop nexthop_address } interface interface_name [ vrf vrf_name ]
no
Disables the specified RRI route.
network-mode { L2 | L3 }
Specifies the RRI route network mode type as Layer 2 (L2) or Layer 3 (L3).
clear_loopback_ip
Specifies the loopback address for clear traffic in IPv4 dotted-decimal notation.
rri-ip
virtual_ip_address
Specifies the use of a virtual IP address on both Primary and Secondary for RRI.
virtual_ip_address
is
expressed in IPv4 dotted-decimal notation.
ip_address
Specified in IPv4 dotted-decimal notation.
next-hop
nexthop_address
Next hop address specified in IPv4 dotted-decimal notation. The next hop IP address is not required for point-
to-point and tunnel interfaces.
to-point and tunnel interfaces.
interface
interface_name
Specifies the name of an existing egress interface as an alphanumeric string of 1 through 79 characters.