Cisco Cisco Packet Data Gateway (PDG)
Exec Mode show Commands (Q-S)
▀ show subscribers samog-only
▄ Command Line Interface Reference, StarOS Release 17
4970
show subscribers samog-only
Displays SaMOG specific context information for the session.
Product
SaMOG
Privilege
Inspector
Syntax
show subscribers samog-only [ [ all ] [ callid call_id ] [ card-num card_num ] [
connected-time [ < | > | greater-than | less-than ] connected_time ] [ full ] [ idle-
time [ < | > | greater-than | less-than ] idle_time ] [ ip-address [ < | > | greater-
than | less-than ] ipv4_adress ] [ ipv6-prefix ipv6_prefix ] [ network-type { gre |
ipip | ipsec | ipv4 | ipv4-pmipv6 | ipv4v6 | ipv4v6-pmipv6 | ipv6 | ipv6-pmipv6 | l2tp |
mobile-ip | proxy-mobile-ip } ] [ session-time-left [ < | > | greater-than | less-than
] session_time_left ] [ smgr-instancesmgr_instance ] [ summary ] [ username user_name
] [ | { grep grep_options | more } ] ]
connected-time [ < | > | greater-than | less-than ] connected_time ] [ full ] [ idle-
time [ < | > | greater-than | less-than ] idle_time ] [ ip-address [ < | > | greater-
than | less-than ] ipv4_adress ] [ ipv6-prefix ipv6_prefix ] [ network-type { gre |
ipip | ipsec | ipv4 | ipv4-pmipv6 | ipv4v6 | ipv4v6-pmipv6 | ipv6 | ipv6-pmipv6 | l2tp |
mobile-ip | proxy-mobile-ip } ] [ session-time-left [ < | > | greater-than | less-than
] session_time_left ] [ smgr-instancesmgr_instance ] [ summary ] [ username user_name
] [ | { grep grep_options | more } ] ]
idle-time [ < | > | greater-than | less-than ]
idle_time
Displays how long the subscriber has been idle.
>
and
greater-than
Specifies greater than. This must be followed by
idle_time
, an integer ranging from
0
and
4294967295
.
<
and
less-than
Specifies less than. This must be followed by
idle_time
, an integer ranging from
0
and
4294967295
.
ipv6-prefix
ipv6_prefix
Displays the subscribers associated with the specified IPv6 address prefix. Must be followed by an IPv6 address prefix
in the format xx:xx:xx::/len
in the format xx:xx:xx::/len
| { grep grep_options
| more }
Pipes (sends) the output of this command to a specified command. You must specify a command to which the
output of this command will be sent.
For details on using the
output of this command will be sent.
For details on using the
grep
and
more
commands, refer to the Regulating a Command’s Output section of
the Command Line Interface Overview chapter.