Cisco Cisco Packet Data Gateway (PDG)
Linkset Configuration Mode Commands
link ▀
Command Line Interface Reference, StarOS Release 17 ▄
6853
link
This command creates an MTP3 link configuration for the SS7 linkset and enters the Link configuration mode.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > SS7 Routing Domain Configuration > Linkset Configuration
configure > ss7-routing-domain domain_id variant var_type > linkset id linkset_id
Entering the above command sequence results in the following prompt:
[local]host_name(config-ss7-rd-linkset-linkset_id)#
Syntax
link id id [ link-type [ atm-broadband | highspeed-narrowband | lowspeed-narrowband ]
no link id id
no
Disables the specified link configuration.
Important:
Removing the link configuration will result in the termination of traffic on the specified link.
#_octets
Sets the number of octets for the length of the LSSU.
id
This number uniquely identifies the link in the linkset.
id:
an integer between 1 and 16.
link-type
Identifies the signalling type for this link; options include:
ATM broadband -- ATM AAL5 over an optical line card (OLC2)
high speed-narrowband -- 64 kbps over a channelized optical line card (CLC2)
low speed-narrowband -- 4.8 kbps over a channelized optical line card (CLC2)
Important:
Be default link-type is ATM-broadband. To support narrowband SS7, one of the other options must
be set.