Cisco Cisco Packet Data Gateway (PDG)
MRME Service Configuration Mode Commands
▀ radius
▄ Command Line Interface Reference, StarOS Release 17
7354
radius
This command allows you to specify the IP address and shared secret of the RADIUS accounting and authentication
client from which RADIUS accounting and authentication requests are received.
client from which RADIUS accounting and authentication requests are received.
Important:
From release 16.0 onwards, this command has been deprecated. Instead, use the
radius
command
described under the TWAN Profile Configuration Mode Commands section.
Product
SaMOG
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > MRME Service Configuration
configure > context context_name > mrme-service
mrme_service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-mrme-service)#
Syntax
radius client ipv4_address[/mask] { [ encrypted ] key key [ [ disconnect-message [ dest-
port port_number ] ] [ acct-onoff { [ aaa-context aaa_context_name ] [ aaa-group
aaa_group_name ] [ clear-sessions ] } ] }
port port_number ] ] [ acct-onoff { [ aaa-context aaa_context_name ] [ aaa-group
aaa_group_name ] [ clear-sessions ] } ] }
no radius client ipv4_address[/mask]
no
Removes a previously coonfigured RADIUS client.
ipv4_address[/mask]
Specifies the IP address, and optional subnet mask of the RADIUS client from which RADIUS accounting
and authentication requests are received.
and authentication requests are received.
ipv4_address[/mask]
must be an IPv4 address expressed in dotted-decimal notation.
[ encrypted ] key key
encrypted
: Specifies that the shared key between the RADIUS client and this service is encrypted.
key key
: Specifies the shared key between the RADIUS client and this service.
key
with encryption must be an alphanumeric string of 1 through 288 characters, and without
encryption an alphanumeric string of 1 through 127 characters. Note that
key
is case sensitive.
disconnect-message [ dest-port port_number ]
Specifies to send RADIUS disconnect messages to the configured RADIUS accounting client in call failure
scenarios.
scenarios.
dest-port port_number
: Specifies a port number to which the disconnect message must be sent.