Cisco Cisco Packet Data Gateway (PDG)

Pagina di 8994
  ORBEM Configuration Mode Commands 
iiop-port  ▀   
 
Command Line Interface Reference, StarOS Release 17  ▄  
 
   
7427 
iiop-port 
Configures the port number for Internet Inter-ORB Protocol (IIOP) communications. 
Product
 
All 
Privilege
 
Security Administrator, Administrator 
Mode
 
Exec > Global Configuration > ORBEM Configuration 
configure > orbem
 
Entering the above command sequence results in the following prompt: 
[local]host_name(config-orbem)# 
Syntax
 
[ no ] iiop-port number 
default
 
Restores the port number for inter-ORB communications to the system default: 14132. 
no
 
Disables the IIOP port. 
number
 
Specifies the port number to use as an integer from 1 through 65535. Default: 14132 
Usage 
Explicitly set the port number when the default port number is not the desired port value for integrating 
multiple products together for standardized inter-ORB communications. 
Internet inter-ORB port is only used if IIOP transport is enabled via the 
iiop-transport
 command. 
Example
 
The following commands sets the IIOP port number to 2546: 
iiop-port 2546