Cisco Cisco Packet Data Gateway (PDG)
Service Redundancy Protocol Configuration Mode Commands
monitor hsrp ▀
Command Line Interface Reference, StarOS Release 17 ▄
8375
monitor hsrp
Enables monitoring of the Hot Standby Router Protocol (HSRP) connection between the ASR 9000 Route Switch
Processor (RSP) and the StarOS Security Gateway (SecGW) running in a virtual machine on the Virtualized Services
Module. HSRP is employed in high availability (HA) SecGW configurations. (ASR 9000 VSM only)
Processor (RSP) and the StarOS Security Gateway (SecGW) running in a virtual machine on the Virtualized Services
Module. HSRP is employed in high availability (HA) SecGW configurations. (ASR 9000 VSM only)
Product
SecGW
Privilege
System Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Service Redundancy Protocol Configuration
configure > context context_name > service-redundancy-protocol
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-srp)#
Syntax
monitor hsrp interface if_name afi-type type hsrp-group hsrp_group
no monitor hsrp
no
Turns off the monitoring.
interface
if_name
Specifies the name of an existing RSP interface as an alphanumeric string of 1 through 63 characters.
afi-type
type
Specifies the RSP name of an existing Address Family Type (IPv4 or IPv6) as an alphanumeric string of 4
through 15 characters.
through 15 characters.
hsrp-group
hsrp_group
Specifies the RSP name of an existing HSRP Group ID as an integer from 0 through 4095.
Usage
Use this command to enable monitoring of the HSRP connection between the ASR 9000 RSP and the SecGW
running in a virtual machine on the VSM.
This command must be associated with the Service Redundancy Protocol (SRP) context.
A maximum of one HSRP monitor is supported per VPC-VSM instance.
running in a virtual machine on the VSM.
This command must be associated with the Service Redundancy Protocol (SRP) context.
A maximum of one HSRP monitor is supported per VPC-VSM instance.
Important:
The above parameters must match those of the HSRP configuration in the ASR 9000 RSP.
Example