Cisco Cisco Packet Data Gateway (PDG)
APN Configuration Mode Commands
▀ ip access-group
▄ Command Line Interface Reference, StarOS Release 16
1330
ip access-group
Configures an IPv4/IPv6 access group for the current APN profile.
Product
ACS
eWAG
GGSN
P-GW
SAEGW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > APN Configuration
configure > context context_name > apn apn_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-apn)#
Syntax
ip access-group acl_group_name [ in | out ] [ fallback-enabled ]
[ no ] ip access-group acl_group_name [ in | out ]
no
Removes a previously configured IPv4/IPv6 access group association.
acl_group_name
Specifies the name of the IPv4/IPv6 access group.
acl_group_name
is a previously configured ACL group
expressed as an alphanumeric string of 1 to 79 characters.
in | out
Default: both (in and out)
Specifies the access-group as either inbound or outbound by the keywords
Specifies the access-group as either inbound or outbound by the keywords
in
and
out
, respectively.
Usage
Use this command to apply a single IPv4/IPv6 access control list to multiple subscribers via this APN for
inbound or outbound IPv4/IPv6 traffic.
If no traffic direction is specified, the selected access control list will be applied to both directions.
inbound or outbound IPv4/IPv6 traffic.
If no traffic direction is specified, the selected access control list will be applied to both directions.
Example
The following command associates the
sampleipv4Group
access group with the current APN profile for
both inbound and outbound access.
ip access-group sampleipv4Group