Cisco Cisco Packet Data Gateway (PDG)
BMSC Profile Configuration Mode Commands
▀ gmb user-data
▄ Command Line Interface Reference, StarOS Release 16
1648
gmb user-data
This command configures the parameters in this BMSC profile for user data for MBMS user service.
Product
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > BMSC Profile Configuration
configure > context context_name > bmsc-profile profile_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-bmsc-profile)#
Syntax
gmb user-data { mode-preference { multicast | unicast } | unicast-self-address
self_ip_address }
self_ip_address }
default gmb user-data mode-preference
no gmb user-data unicast-self-address
no
Removes the configured self address of GGSN for unicast in the BMSC profile for user data of MBMS user
service.
service.
defualt
Sets the user data mode to unicast in the BMSC profile for user data of MBMS user service.
mode-preference { multicast | unicast }
Default: unicast
Specifies the preferred mode of GGSN for receiving MBMS user service data.
Specifies the preferred mode of GGSN for receiving MBMS user service data.
multicast
: specifies the preferred mode as multicast for MBMS user service.
Important:
Note that this multicast keyword is not supported in this release.
unicast
: specifies the preferred mode as unicast for MBMS user service.
unicast-self-address self_ip_address
Specifies the GGSN’s IP address for BMSC to use as the outer destination address for the IP-in-IP tunnel to
send multicast data, if the configured preferred data mode is unicast.
send multicast data, if the configured preferred data mode is unicast.
self_ip_address
must be the IPv4 address in dotted-decimal notation.
This command must be configured if GGSN's user-data mode-preference is Unicast.