Cisco Cisco Packet Data Gateway (PDG)
Ethernet Port Configuration Mode Commands
▀ flow-control
▄ Command Line Interface Reference, StarOS Release 16
3642
flow-control
Enables and disables flow control on the ASR 5000 Quad Gig-E line card (QGLC) and the ASR 5500 MIO card.
Product
PDSN
SGSN
GGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Ethernet Port Configuration
configure > port ethernet slot_number/port_number
Entering the above command sequence results in the following prompt:
[local]host_name(config-port-slot_number/port_number)#
Syntax
[ no ] flow-control
no
Disables flow control on the specified port.
Usage
Flow control is enabled by default on the QGLC and can be disabled using the
no
command on a per-port
basis. This command does not work on the Fast Ethernet Line Card (FELC), Gigabit Ethernet Line Card
(GELC/GLC2) or 10 GigE Line Card (XGLC) which do not support flow control.
Flow control is not supported on the MIO card.
(GELC/GLC2) or 10 GigE Line Card (XGLC) which do not support flow control.
Flow control is not supported on the MIO card.
Example
After flow control has been disabled, use the following command to enable flow control:
flow-control