Cisco Cisco Packet Data Gateway (PDG)
Global Configuration Mode Commands (L-S)
link-aggregation ▀
Command Line Interface Reference, StarOS Release 16 ▄
5291
link-aggregation
Configures system MAC address and priority for Link Aggregation. These parameters are usually changed to match the
feature requirements of the remote Ethernet switch.
feature requirements of the remote Ethernet switch.
Product
WiMAX
PDSN
HA
FA
GGSN
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration
configure
Entering the above command sequence results in the following prompt:
[local]host_name(config)#
Syntax
link-aggregation { system-mac { MAC_address | auto } | system-priority priority } [-
noconfirm ]
noconfirm ]
{ default | no } link-aggregation { system-mac | system-priority } [-noconfirm ]
default
Resets the configuration to the default.
system-mac {
MAC_address
| auto }
Sets the system MAC address used along with the system priority to form the system ID.
MAC_address
is manually entered as six groups of two hexadecimal digits separated by hyphens (for
example, 01-23-45-67-89-ab).
Auto is the default and is the MAC address of the LAG master port.
Auto is the default and is the MAC address of the LAG master port.
system-priority priority
This command sets the system priority used by Link Aggregation Control Protocol (LACP) to form the
system ID.
system ID.
priority
is a hexadecimal value from 0x0000 through 0xFFFF. Default is 0x8000 (32768).
-noconfirm
Executes the command without additional prompting for command confirmation.