Cisco Cisco Packet Data Gateway (PDG)
LTE Policy Configuration Mode Commands
▀ cause-code-group
▄ Command Line Interface Reference, StarOS Release 16
6930
cause-code-group
Creates a new cause code group, or specifies an existing cause code group and enters the Cause Code Group
Configuration Mode.
Configuration Mode.
Product
MME
Privilege
Administrator
Mode
Exec > Global Configuration > LTE Policy Configuration
configure > lte-policy
Entering the above command sequence results in the following prompt:
[local]host_name(lte-policy)#
Syntax
cause-code-group group_name protocol s1ap
no cause-code-group group_name
no
Removes the specified cause code group with all related configuration from the LTE Policy.
group_name
Specify a name of a cause-code-group to create, modify, or remove. This name must be an alphanumeric
string of 1 through 16 characters. Each new cause-code-group must have a unique name.
A maximum of 4 cause code groups can be defined across all services (MME+GPRS+SGSN).
string of 1 through 16 characters. Each new cause-code-group must have a unique name.
A maximum of 4 cause code groups can be defined across all services (MME+GPRS+SGSN).
protocol
Specifies the protocol for the cause code group being created/accessed. Options include:
S1-AP
Usage
Use this command to create or modify a group of cause codes.
Entering this command results in a prompt, with the protocol ID included, similar to the following:
Entering this command results in a prompt, with the protocol ID included, similar to the following:
[context_name]hostname(s1ap-cause-code)#
Depending upon the protocol you have selected, the Cause Code Group configuration commands are defined
in the
in the
S1AP Cause Code Configuration Mode Commands chapter of this guide.
Example
The following command creates an S1-AP cause code group named move-ue-to-idle.