Cisco Cisco Packet Data Gateway (PDG)
ACS Rulebase Configuration Mode Commands
tethering-detection ▀
Command Line Interface Reference, StarOS Release 16 ▄
757
tethering-detection
This command allows you to enable/disable the Tethering Detection feature for the current rulebase, and specifies the
database to use.
database to use.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Rulebase Configuration
active-charging service service_name > rulebase rulebase_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-rule-base)#
Syntax
tethering-detection { os-db-only | ua-db-only }
{ default | no } tethering-detection
default
Configures this command with its default setting.
Default: By default, the Tethering Detection feature is disabled. When enabled, unless a specific database is
specified to be used, by default tethering detection will make use of both the databases.
Default: By default, the Tethering Detection feature is disabled. When enabled, unless a specific database is
specified to be used, by default tethering detection will make use of both the databases.
no
If previously configured, deletes the tethering detection configuration from the current rulebase.
os-db-only
Specifies to perform tethering detection using only the OS signature database.
ua-db-only
Specifies to perform tethering detection using only the UA signature database.
Usage
Use this command to enable/disable the Tethering Detection feature for a rulebase, and configures the
database to use.
Changing the configuration does not affect existing flows of the subscriber. If Tethering Detection was
disabled and is turned enabled, it will be applied only to new flows of subscribers using the rulebase.
Also, see the
database to use.
Changing the configuration does not affect existing flows of the subscriber. If Tethering Detection was
disabled and is turned enabled, it will be applied only to new flows of subscribers using the rulebase.
Also, see the
tethering-database
command in the ACS Configuration Mode Commands chapter.
Example
The following command enables the Tethering Detection feature in the rulebase, and specifies to use only the
OS database:
OS database:
tethering-detection os-db-only