Cisco Cisco Packet Data Gateway (PDG)
ACS Ruledef Configuration Mode Commands
bearer traffic-group ▀
Command Line Interface Reference, StarOS Release 16 ▄
795
bearer traffic-group
This command allows you to define rule expressions to match traffic group number associated with the subscriber
session.
session.
Important:
This functionality is available only if the Content Access Control license has been installed on the
chassis.
Product
ACS
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Ruledef Configuration
active-charging service service_name > ruledef ruledef_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-acs-ruledef)#
Syntax
[ no ] bearer traffic-group operator group_number
no
If previously configured, deletes the specified rule expression from the current ruledef.
operator
Specifies how to match.
operator
must be one of the following:
!=
: Does not equal
<=
: Lesser than or equals
=
: Equals
>=
: Greater than or equals
group_number
Specifies the traffic group number to match.
group_number
must be an integer from 1 through 255.
Usage
Use this command to define rule expressions to match traffic group of the subscriber session. See the
fa-ha-
spi
command in the HA Service Configuration Mode Commands chapter for more information.
Example
The following command defines a rule expression to analyze all traffic groups assigned a value greater or
equal to
equal to
23
: