Cisco Cisco Packet Data Gateway (PDG)
WSG Service Configuration Mode Commands
ipv6 ▀
Command Line Interface Reference, StarOS Release 16 ▄
8765
ipv6
Specifies the IPv6 access group and prefix pool for this WSG service (VPC only).
Product
SecGW (WSG)
Privilege
Security Administrator
Mode
Exec > Global Configuration > Context Configuration > WSG-Service Configuration
configure > context context_name > wsg-service
service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-wsg-service)#
Syntax
ipv6 { access-group group_name | address prefix-pool pool_name }
no ipv6 access-group group_name
no ipv6 address prefix-pool
no
Deletes the specified parameter.
access-group
group_name
Specifies an existing IPv6 ACL access group as an alphanumeric string of 1 through 47 characters. For
additional information, see IPv6 ACL Configuration Mode Commands.
additional information, see IPv6 ACL Configuration Mode Commands.
address prefix-pool
pool_name
Specifies an existing IPv6 prefix pool as an alphanumeric string of 1 through 31 characters. For additional
information, see Subscriber Configuration Mode Commands.
information, see Subscriber Configuration Mode Commands.
Usage
Specify the IPv6 access group and prefix pool for this WSG service.
This command and its keywords are subject to the following limitations:
This command and its keywords are subject to the following limitations:
The WSG service configuration takes precedence over the equivalent configuration in Subscriber mode
or the template payload.
The WSG service must be restarted to apply the parameters. You restart the service by doing an unbind
and bind.
One named IPv6 pool can be configured.
One named IPv6 ACL can be configured.
The IPv6 pools will only be used for IPv6 calls.
Example