Cisco Cisco Packet Data Gateway (PDG)

Pagina di 655
SGSN Changes in Release 17   
▀  SGSN Enhancements for 17.0 
 
 
▄  Release Change Reference, StarOS Release 17 
494 
   
        no radio-cause cause_code  
        end 
Notes: 
 
radio-cause
: A maximum of 16 BSSGP protocol radio cause codes can be defined per group. Note that under 
each cause code group the maximum number of cause codes (ranap+bssgp+s1ap) that can be supported is 16.  
 
cause_code 
: Enter an integer from 0 to 255 to identify a BSSGP protocol radio cause code, as defined in the 
Radio Cause section of the 3GPP TS 48.028 specification.  
 
no
: When included with the command, the specified cause code is deleted from the group. If all cause codes are 
deleted from the group then the group is automatically deleted. 
Important:
  The SGSN does not support Enhanced Radio Status functionality; therefore, the SGSN treats cause 
code values 0x03 and 0x04 as “Radio contact lost with MS”. Therefore, the valid configurable cause codes values are 0, 
1, and 2.  
cause
 
This new command, in the new RANAP Cause Code configuration mode, enables the operator to define multiple cause 
codes for the 3G service so that  
 
if the RANAP cause code configured by the operator matches with the cause received in the Iu-Release Request 
message, and  
 
if the Subscriber Overcharging Protection feature is enabled for 3G service in the SGSN-Service configuration 
(see command information above),  
 
then the S4-SGSN includes ARRL (i.e., Abnormal Release of Radio Link) bit in Release Access Bearer Request 
message initiated on Iu-Release. 
configure 
 lte-policy 
     cause-code-group group_name protocol ranap 
        cause cause_code  
        cause cause_code  
        cause cause_code  
        no cause cause_code  
        end 
Notes: 
 
cause
: A maximum of 16 RANAP protocol cause codes can be defined per group. Note that under each cause 
code group the maximum number of cause codes (ranap+bssgp+s1ap) that can be supported is 16.  
 
cause_code 
: Enter an integer from 1 to 512 to identify a cause code. Valid options are listed in 3GPP TS 
25.413 v11.5.0 (or later version), subsection on Cause in subsection for Radio Network Layer Related IEs.