Cisco Cisco Packet Data Gateway (PDG)
S-GW Changes in Release 17
▀ S-GW Enhancements for 17.0
▄ Release Change Reference, StarOS Release 17
578
peer-ip-address { ipv4-address ipv4_address | ipv6-address ipv6_address
no peer-ip-address { ipv4-address ipv4_address | ipv6-address ipv6_address
end
Notes:
peer-ip-address
configures an IPv4/IPv6 address as part of an MME or S4-SGSN pool.
ntsr pool-id
This new command in Peer-Profile Configuration Mode enables network triggered service restoration (ntsr) and
identifies the Pool ID to use for the feature.
identifies the Pool ID to use for the feature.
configure
peer-profile service-type sgw-access name profile_name
ntsr pool-id number
no ntsr pool-id number
end
Notes:
ntsr pool-id
is the network triggered service restoration pool ID. Must be an integer from 1 to 65535.
ntsr session-hold timeout <number>
This command has been added to S-GW Service Configuration Mode to configure a timer to hold the session after path
failure is detected during MME restoration.
failure is detected during MME restoration.
configure
context ingress_context_name
sgw-service sgw-service_name
ntsr session-hold timeout duration_seconds
no ntsr session-hold timeout
end
Notes:
ntsr session-hold timeout
configures the timer duration, in seconds, that determines how long the session
will be held after path failure is detected during MME restoration. Valid entries are from 1 to 3600 seconds.
peer-ip-address
This command configures the peer type for an MME or S4-SGSN pool.
configure