Cisco Cisco Packet Data Gateway (PDG)
GGSN Changes in Release 16
GGSN Enhancements for 16.0 ▀
Release Change Reference, StarOS Release 16 ▄
159
qci6-relbear
qci7-actbear
qci7-setupbear
qci7-relbear
qci8-actbear
qci8-setupbear
qci8-relbear
qci9-actbear
qci9-setupbear
qci9-relbear
CSCun51617 - [gn-gp]: GGSN Not Informing PCRF about Network-Request-
Support Change
Feature Changes
BCM Mode Derivation during gn-gp Handoff
Previous Behavior: Earlier the UE support for bearer control mode (BCM) was unknown on handover from PGW to
GGSN and therefore BCM would not be derived as expected.
GGSN and therefore BCM would not be derived as expected.
New Behavior: With new changes, even if PCO IE is not sent in handover indication to GGSN but previously sent to
PGW during call setup, BCM will be derived based on UE support in PGW.
PGW during call setup, BCM will be derived based on UE support in PGW.
Customer Impact: BCM mode will be derived based on UE and SGSN support on handover rather than assuming
BCM in PGW to be always by UE.
BCM in PGW to be always by UE.
CSCty95123 - Always-ON license for GGSN
Feature Changes
Always On License for GGSN
Previous Behavior: Bulkstats for considering number of active-call for GGSN was not available. Similar type of
bulkstat were present for MME, P-GW, and S-GW products.
bulkstat were present for MME, P-GW, and S-GW products.
New Behavior: “ggsn-activedata” bulkstat support has been added.
Customer Impact: Number of active GGSN call count shall be available.
Performance Indicator Changes
System Schema