Cisco Cisco Packet Data Gateway (PDG)
Configuring the SaMOG Gateway
▀ Configuring the System to Perform as a SaMOG Gateway
▄ SaMOG Administration Guide, StarOS Release 19
106
Configuring the System to Perform as a SaMOG Gateway
This section provides a high-level series of steps and the associated configuration file examples for configuring the
system to perform as a SaMOG Gateway in a test environment. For a configuration example without instructions, see
the Sample SaMOG Gateway Configuration File section in this guide.
system to perform as a SaMOG Gateway in a test environment. For a configuration example without instructions, see
the Sample SaMOG Gateway Configuration File section in this guide.
Required Information
The following sections describe the minimum amount of information required to configure and make the SaMOG
Gateway operational in the network. To make the process more efficient, it is recommended that this information be
available prior to configuring the system.
Gateway operational in the network. To make the process more efficient, it is recommended that this information be
available prior to configuring the system.
The following table lists the information that is required to configure the SaMOG Gateway context and service.
Table 29. Required Information for SaMOG Configuration
Required Information
Description
SaMOG Context and MRME, CGW and SaMOG Service Configuration
SaMOG context name
The name of the SaMOG context, which can be from 1 to 79 alpha and/or numeric
characters.
characters.
MRME service name
The name of the MRME service, which can be from 1 to 63 alpha and/or numeric
characters.
characters.
IPv4 address
The IP address to which you want to bind the MRME service.
context DNS
The name of the context to use for PGW DNS.
IPV4_address/subnetmask
The IPv4 address and subnetmask for the destination RADIUS client the MRME
service will use.
service will use.
Key
The name of the encrypted key for use by the destination RADIUS server.
Port Number
The port number for RADIUS disconnect messages.
IPv4 address
The IPv4 address of the RADIUS client
Key
The encrypted key name for use by the RADIUS client.
Port
The port number used by the RADIUS client.
CGW service name
The name of the CGW service, which can be from 1 to 63 alpha and/or numeric
characters.
characters.
IPv4 address
The IPv4 address to which the CGW service will bind.
Egress EGTP service name
The name of the egress EGTP service that the CGW service will use. This name must
match the name of the EGTP service configured later in this procedure.
match the name of the EGTP service configured later in this procedure.
Timeout
The session delete delay timeout setting for use by CGW service.
SaMOG service name
The name of the SaMOG service, which can be from 1 to 63 alpha and/or numeric
characters.
characters.