Cisco Cisco Packet Data Gateway (PDG)

 

▄  Statistics and Counters Reference, StarOS Release 18  

 

 

Service name 

The name of the service configured in the named context. 

Service-ID 

A system generated ID number applied to the service. 

Context 

The name of the context where the service is configured. 

Interface Type 

The type of LTE interface this service is supporting. 
The following fields are in the output of the show egtp-service all command to accept or reject Create 
Session Request (CSR) on GTP based S2a and S2b interfaces. 



 

s5/s8 



 

s2a 



 

s2b 

 This is a license-controlled feature. A valid feature license must be 

installed prior to configuring this feature. Contact your Cisco account representative for more 
information. These fields are only visible if the license is enabled. 

Status 

The status of the service, i.e., “STARTED”. 

Restart Counter 

Specifies the restart counter 

Message Validation 
Mode 

The type of IE validation to be performed on messages received by this service. 

GTPC Retransmission 
Timeout 

The number of seconds between the re-sending of GTP-C echo messages. 

GTPC Maximum 
Request 
Retransmissions 

The number of control packet request message retransmissions that can be sent before an error condition 
is established. 

GTPC IP QOS DSCP 
value 

The IP QoS DSCP per-hop behavior to be marked on the outer header of signalling packets originating 
from the LTE component. 

GTPC Echo 

Identifies if GTP-C echo messages will be sent. 

GTPC Echo Interval 

The duration between the sending of GTP-C echo messages. 

GTP-C Bind IPv4 
Address 

The IPv4 address of the interface to which this service is bound. 

GTP-C Bind IPv6 
Address 

The IPv6 address of the interface to which this service is bound.