Cisco Cisco Packet Data Gateway (PDG) Dépliant
Firewall-and-NAT Policy Configuration Mode Commands
▀ nat icsr-flow-recovery
▄ Cisco ASR 5x00 Command Line Interface Reference
4862
nat icsr-flow-recovery
This command enables/disables the NAT ICSR Flow checkpointing support for subscribers in a Firewall-and-NAT
policy. This command is deprecated in StarOS 14.0 and later releases, and is replaced by the
policy. This command is deprecated in StarOS 14.0 and later releases, and is replaced by the
nat check-point-info
command.
Product
NAT
Privilege
Security Administrator, Administrator
Mode
Exec > ACS Configuration > Firewall-and-NAT Policy Configuration
active-charging service service_name > fw-and-nat policy policy_name
Entering the above command sequence results in the following prompt:
[local]host_name(config-fw-and-nat-policy)#
Syntax
[ default | no ] nat icsr-flow-recovery
default
Configures the default setting.
Default: Disabled. Same as
Default: Disabled. Same as
no icsr-flow-recovery
.
no
Disables the NAT ICSR Flow checkpointing.
Usage
Use this command to enable/disable all NAT ICSR Flow checkpointing for subscribers using this policy.
Example
The following command enables NAT ICSR Flow checkpointing:
nat icsr-flow-recovery