Cisco Cisco Packet Data Gateway (PDG) Dépliant
PVC Interface Configuration Mode Commands
▀ ip ospf dead-interval
▄ Cisco ASR 5x00 Command Line Interface Reference
7706
ip ospf dead-interval
This command configures the dead-interval and the delay time in seconds, for OSPF communications.
Product
SGSN
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > PVC Interface Configuration
configure > context context_name > interface interface_name point-to-point
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-if-pvc)#
Syntax
ip ospf dead-interval value
no ip ospf dead-interval
no
Deletes the value set and returns the value to its default.
value
The interval, in seconds, that the router should wait. During this interval, if no packets are received then the
system considers the neighboring router to be off-line. This interval is typically 4 times the duration of the
hello-interval.
system considers the neighboring router to be off-line. This interval is typically 4 times the duration of the
hello-interval.
value
must be an integer from 1 through 65535. Default: 40
Usage
Use this command to set the dead-intervals or delays for OSPF communications.
Example
To set the dead-interval to 100, use the following command;
ip ospf dead-interval 100
To delete the setting for the dead-interval and reset the dead-interval value to its default of 40, use the
following command’
following command’
no ip ospf dead-interval