Cisco Cisco Packet Data Gateway (PDG) Dépliant
S-GW Service Configuration Mode Commands
page-ue ▀
Cisco ASR 5x00 Command Line Interface Reference ▄
8161
page-ue
Allows the S-GW to page the UE for P-GW-initiated procedures (Create Bearer Request (CBR)/Modify Bearer Request
(MBR)/Update Bearer Request (UBR)) when the UE is idle, and sends a failure response to the P-GW with the cause
code 110 (Temporary Failure) when the UE is idle or a collision is detected at the S-GW.
(MBR)/Update Bearer Request (UBR)) when the UE is idle, and sends a failure response to the P-GW with the cause
code 110 (Temporary Failure) when the UE is idle or a collision is detected at the S-GW.
Product
S-GW
SAEGW
Privilege
Administrator
Mode
Exec > Global Configuration > Context Configuration > S-GW Service Configuration
configure > context context_name > sgw-service service_name
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-sgw-service)#
Syntax
[ default | no ] page-ue pgw-initiated-proc
default
Returns the command to its default setting of disabled.
no
Disables the feature.
pgw-initiated-proc
Sets the command to page the UE for P-GW initiated MBR, UBR, and CBR procedures.
Usage
Use this command to allow the S-GW to page a UE for P-GW-initiated procedures (CBR/MBR/UBR) when
the UE is idle, and sends a failure response to the P-GW with the cause code 110 (Temporary Failure) when
the UE is idle or a collision is detected at the S-GW.
the UE is idle, and sends a failure response to the P-GW with the cause code 110 (Temporary Failure) when
the UE is idle or a collision is detected at the S-GW.
Example
The following command enable the S-GW to page the UE