Cisco Cisco Packet Data Gateway (PDG) Dépliant
Subscriber Configuration Mode Commands
▀ asn-policy
▄ Cisco ASR 5x00 Command Line Interface Reference
8218
asn-policy
Configures the identifiers for packet data flow, service data flow, and service profile in an ASN-GW service.
Product
ASN-GW
Privilege
Security Administrator, Administrator
Mode
Exec > Global Configuration > Context Configuration > Subscriber Configuration
configure > context context_name > subscriber { default | name subscriber_name }
Entering the above command sequence results in the following prompt:
[context_name]host_name(config-subscriber)#
Syntax
asn-policy [classifiers downlink { strict | loose} | idle-mode { allow | disallow } |
notification-idle-mode {allow | disallow} | notification-handoff { allow | disallow
}auth-only {allow | disallow } | ms-requested-classifiers {allow | dissalow}]
notification-idle-mode {allow | disallow} | notification-handoff { allow | disallow
}auth-only {allow | disallow } | ms-requested-classifiers {allow | dissalow}]
[ default ] asn-policy classifiers downlinkidle-mode
no
Removes or disables the configured policy for this subscriber in ASN-GW service.
default
Sets the ASN policy to default for this subscriber.
For downlink traffic classifier default policy is “loos” and for idle mode policy the default action is to allow
idle mode operation in an ASN-GW service.
For downlink traffic classifier default policy is “loos” and for idle mode policy the default action is to allow
idle mode operation in an ASN-GW service.
idle-mode
Sets the idle mode policy for this subscriber in an ASN-GW service. If enabled, Interim-Update is sent with
the BSID and WiMAX-Idle_Mode Transition as Idle. If disabled, the Interim can be sent when the call is in
the idle mode based on the interim timer. At this point, the last known BSID is reported to the RADIUS
server.
the BSID and WiMAX-Idle_Mode Transition as Idle. If disabled, the Interim can be sent when the call is in
the idle mode based on the interim timer. At this point, the last known BSID is reported to the RADIUS
server.
notification-idle-mode
Default: allow
Use to enable or disable Idle-Mode-Notification capabilities. When you enable this command, when the call
moves from active to idle, or idle to active, Accounting Interim is sent.
Use to enable or disable Idle-Mode-Notification capabilities. When you enable this command, when the call
moves from active to idle, or idle to active, Accounting Interim is sent.
notification-handoff
Default: allow
If enabled, the Interim-Update is sent with the BSID and SN-Handoff-Indicator as Active Handoff.
If enabled, the Interim-Update is sent with the BSID and SN-Handoff-Indicator as Active Handoff.