Cisco Cisco Packet Data Gateway (PDG)
show card
▀
▄ Statistics and Counters Reference, StarOS Release 16
3656
Field
Description
Status
Status is reported for the following items:
IDEEPROM Magic Number: Indicates whether or not the device map has been
initialized. The ID EEPROM device stores hardware, diagnostic and software
configuration data.
initialized. The ID EEPROM device stores hardware, diagnostic and software
configuration data.
Boot Mode: Displays the current boot mode. – Normal (boot to StarOS, default
mode), Extended diagnostics or Diagnostic CLI.
mode), Extended diagnostics or Diagnostic CLI.
Card Diagnostics: Indicates the current status of the card's internal diagnostics. The
two possible states are: Pass (all diagnostics passed) and Failed one or more
diagnostics did not pass).
two possible states are: Pass (all diagnostics passed) and Failed one or more
diagnostics did not pass).
Current Failure: Indicates any failure that is currently being reported by this card. If
no failures were detected, this item will display None.
no failures were detected, this item will display None.
Last Failure: Indicates the last failure reported by this card since its event log was last
cleared.
cleared.
Card Usable: Indicates whether or not the card is usable. “Usability” is based on the
operational state of the card (active, standby, or offline), whether or not the
Administrative state is enabled (the card is configured for use via software), and
whether or not the card’s interlock switch is locked. Either a Yes or a No will be
displayed.
operational state of the card (active, standby, or offline), whether or not the
Administrative state is enabled (the card is configured for use via software), and
whether or not the card’s interlock switch is locked. Either a Yes or a No will be
displayed.
Last Reset Cause: Indicates the cause for the last reset of this card.
Note: This field only appears if a card reset has occurred.
Boot/Diag Log
ASR 5000 only
ASR 5000 only
Displays the contents of the boot and diagnostics log.
NOTE: The boot and diagnostic log contents are not displayed for line card diagnostics.
NOTE: The boot and diagnostic log contents are not displayed for line card diagnostics.
Error Log
ASR 5000 only
ASR 5000 only
Displays the contents of the error log.
NOTE: The error log contents are not displayed for line card diagnostics.
NOTE: The error log contents are not displayed for line card diagnostics.
Current
Environment
Not displayed
for QvPC-SI
Environment
Not displayed
for QvPC-SI
Displays the results for the following measurements:
Temperature measurements: Indicates the current operating temperatures and
provides the maximum safe temperature for comparison.
provides the maximum safe temperature for comparison.
Voltage measurements: Indicates the current input status for the various DC sources
and provides the acceptable upper and lower limits for comparison.
and provides the acceptable upper and lower limits for comparison.
show card hardware (ASR 5000)
Table 229.
show card hardware
Command Output Descriptions (ASR 5000)
Field
Description