Cisco Cisco Packet Data Gateway (PDG)
Interchassis Session Recovery
ICSR Configuration ▀
VPC-VSM System Administration Guide, StarOS Release 19 ▄
259
af23 – Assured Forwarding Class 2 high drop PHB
af31 – Assured Forwarding Class 3 low drop PHB
af32 – Assured Forwarding Class 3 medium drop PHB
af33 – Assured Forwarding Class 3 high drop PHB
af41 – Assured Forwarding Class 4 low drop PHB
af42 – Assured Forwarding Class 4 medium drop PHB
af43 – Assured Forwarding Class 4 high drop PHB
be – Best effort Per-Hop-Behaviour (default)
cs1 – Class selector 1 PHB
cs2 – Class selector 2 PHB
cs3 – Class selector 3 PHB
cs4 – Class selector 4 PHB
cs5 – Class selector 5 PHB
cs6 – Class selector 6 PHB
cs7 – Class selector 7 PHB
ef – Expedited Forwarding PHB, for low latency traffic
Configuring the SRP Context Interface Parameters
This procedure configures the communication interface with the IP address and port number within the SRP context.
This interface supports inter-process communication.
This interface supports inter-process communication.
Important:
CLI commands must be executed on both VPC-VSM instances. Log into both instances before
continuing. Always make configuration changes on the primary instance first.
Important:
There are only two interfaces available (1/10 and 1/11) for SRP. The SRP interface must be
configured as a VLAN (typically on 1/11).
configure
context srp_ctxt_name [-noconfirm]
interface srp_if_name
ip-address { ip_address | ip_address/mask } srp-activate
exit
exit
port ethernet slot_num/port_num