Cisco Cisco Packet Data Gateway (PDG) Nota Di Rilascio
SAEGW Changes in Release 15.0
SAEGW Enhancements for September 30, 2013 ▀
Cisco ASR 5x00 Release Change Reference ▄
443
1. After handing over the PS sessions to the target, the source MME shall remove the voice bearers by deactivating
the voice bearer(s) towards S-GW/P-GW and setting the VB (Voice Bearer) flag of Bearer Flags IE in the
Delete Bearer Command message (TS 29.274 v9.5.0).
Delete Bearer Command message (TS 29.274 v9.5.0).
2. If the IP-CAN bearer termination is caused by the PS to CS handover, the PCEF may report related PCC rules
for this IP-CAN bearer by including the Rule-Failure-Code AVP set to the value PS_TO_CS_HANDOVER
(TS 29.212 v10.2.0 and TS 23.203 v10.3.0).
(TS 29.212 v10.2.0 and TS 23.203 v10.3.0).
Support for new AVP PS-to-CS-Session-Continuity (added in 3GPP Release 11) inside Charging Rule Install, which
indicates if the bearer is selected for PS to CS continuity is not added.
indicates if the bearer is selected for PS to CS continuity is not added.
SAEGW Command Changes as of September 30, 2013
This section provides information on SAEGW command changes in release 15.0.
Important:
For more information regarding commands in this section, refer to the Command Line Interface
Reference for this release.
New SAEGW Commands
This section identifies new SAEGW commands available in release 15.0.
description
The following new command configures a short description for the specified peer profile.
configure
peer-profile service-type { pgw-access | sgw-network } { default | name profile_name }
[ -noconfirm ]
[ -noconfirm ]
description description
no description
end
gtpc
The following new command configures the GTP-C settings for the specified peer profile.
configure
peer-profile service-type { pgw-access | sgw-network } { default | name profile_name }
[ -noconfirm ]
[ -noconfirm ]
gtpc { echo { interval seconds | retransmission-timeout seconds } | max-
retransmissions number | retransmission-timeout seconds }
retransmissions number | retransmission-timeout seconds }
default gtpc { echo [ interval | retransmission-timeout ] | max-retransmissions |
retransmission-timeout }
retransmission-timeout }
no gtpc echo