Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch Manuale Di Manutenzione
ACL
ACL Rule
Cisco WAP131 and WAP351 Administration Guide
142
8
-
Match to Port—Enter the IANA port number to match to the source port
identified in the datagram header. The port range is 0 to 65535 and
includes three different types of ports:
identified in the datagram header. The port range is 0 to 65535 and
includes three different types of ports:
0 to 1023—Well Known Ports
1024 to 49151—Registered Ports
49152 to 65535—Dynamic and/or Private Ports
-
Mask—Enter the port mask. The mask determines which bits are used
and which bits are ignored. Only the hexadecimal digit (0 – 0xFFFF) is
allowed. 0 means the bit matters and 1 means that we should ignore this
bit.
and which bits are ignored. Only the hexadecimal digit (0 – 0xFFFF) is
allowed. 0 means the bit matters and 1 means that we should ignore this
bit.
•
IPv6 Flow Label—Specifies a 20-bit number that is unique to an IPv6
packet. It is used by end stations to signify QoS handling in routers (range 0
to 1048575).
packet. It is used by end stations to signify QoS handling in routers (range 0
to 1048575).
•
IPv6 DSCP—Matches the packets based on their IP DSCP value. If selected,
choose one of these options as the match criteria:
choose one of these options as the match criteria:
-
Select From List—Choose one of these values: DSCP Assured
Forwarding (AS), Class of Service (CS), or Expedited Forwarding (EF).
Forwarding (AS), Class of Service (CS), or Expedited Forwarding (EF).
-
Match to Value—Enter a custom DSCP value, from 0 to 63.
STEP 6
Click Save. The changes are saved to the Startup Configuration.
NOTE
To delete an ACL, ensure that it is selected in the ACL Name-ACL Type list, check
Delete ACL, and click Save.
Delete ACL, and click Save.
Configure MAC ACLs
To configure a MAC ACL:
STEP 1
Select ACL > ACL Rule.
STEP 2
In the ACL Name field, enter the name to identify the ACL.
STEP 3
Choose MAC as the type of ACL from the ACL Type list. MAC ACLs control
access based on Layer 2 criteria.
access based on Layer 2 criteria.
STEP 4
Click Add ACL.
STEP 5
In the ACL Rule Configuration area, configure these ACL rule parameters: