Cisco Cisco WAP571 Wireless-AC N Premium Dual Radio Access Point with PoE Manuale Di Manutenzione

LAN

Port Settings

Cisco Small Business WAP551 and WAP561 Wireless-N Access Point

53

4

STEP 1

Select LAN > Port Settings in the navigation area.

Port Settings

The Operational Status area shows the type of port used for the LAN port and the Link 
characteristics, as configured in the Administrative Settings area. If the settings change 
through configuration or auto negotiation, you can click Refresh to show the latest settings.

STEP  2

Enable or disable Auto Negotiation.

•

When enabled, the port negotiates with its link partner to set the fastest link speed and 
duplex mode available.

•

When disabled, you can manually configure the port speed and duplex mode.

STEP  3

If autonegotiation is disabled, select a Port Speed (10/100 Mb/s for the WAP121, and 10/100/
1000 Mb/s for the WAP321) and the duplex mode (Half- or Full-duplex).

STEP  4

Enable or disable the Green Ethernet Mode. When enabled, the WAP device automatically 
enters a low-power mode when energy on the line is lost, and it resumes normal operation 
when energy is detected.

STEP  5

Enable or disable Green Ethernet Mode (WAP321 only). 

•

Green Ethernet Mode is an auto-power-down mode that reduces chip power when the 
signal from a link partner is not present. Green Ethernet Mode works whether the port 
has auto-negotiation enabled or disabled. 

•

When Green Ethernet Mode is enabled, the WAP device automatically enters a low-
power mode when energy on the line is lost, and it resumes normal operation when 
energy is detected. 

STEP  6

Click Save. The changes are saved to the Startup Configuration.