Cisco Cisco Aironet 1250 Series Access Point Guida All'Installazione
3
Quick Start Guide: Cisco Aironet 1250 Series Power Injector
Regulatory Information
The following information is for FCC compliance of Class B devices:
The equipment described in this manual generates and may radiate
radio-frequency energy. If it is not installed in accordance with Cisco’s
installation instructions, it may cause interference with radio and television
reception. This equipment has been tested and found to comply with the
limits for a Class B digital device in accordance with the specifications in part
15 of the FCC rules. These specifications are designed to provide reasonable
protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular
installation.
radio-frequency energy. If it is not installed in accordance with Cisco’s
installation instructions, it may cause interference with radio and television
reception. This equipment has been tested and found to comply with the
limits for a Class B digital device in accordance with the specifications in part
15 of the FCC rules. These specifications are designed to provide reasonable
protection against such interference in a residential installation. However,
there is no guarantee that interference will not occur in a particular
installation.
Modifying the equipment without Cisco’s written authorization may result in
the equipment no longer complying with FCC requirements for Class A or
Class B digital devices. In that event, your right to use the equipment may be
limited by FCC regulations, and you may be required to correct any
interference to radio or television communications at your own expense.
the equipment no longer complying with FCC requirements for Class A or
Class B digital devices. In that event, your right to use the equipment may be
limited by FCC regulations, and you may be required to correct any
interference to radio or television communications at your own expense.
You can determine whether your equipment is causing interference by turning
it off. If the interference stops, it was probably caused by the Cisco equipment
or one of its peripheral devices. If the equipment causes interference to radio
or television reception, try to correct the interference by using one or more of
the following measures:
it off. If the interference stops, it was probably caused by the Cisco equipment
or one of its peripheral devices. If the equipment causes interference to radio
or television reception, try to correct the interference by using one or more of
the following measures:
•
Turn the television or radio antenna until the interference stops.