Cisco Multi-Stream CableCARD Module Guida All'Installazione
Chapter 4 Configure the PCG on the DNCS or ISDS
32
78-4017672-01 Rev E
Start the PCG Application
Start the PCG Application
Follow these steps to start the PCG application.
1 Access the PCG via SSH.
2 Type the following command to start or stop the application:
Follow these steps to start the PCG application.
1 Access the PCG via SSH.
2 Type the following command to start or stop the application:
/etc/init.d/pcgmon start
Result: The application starts.
Result: The application starts.
3 Continue by performing the procedures in the section
Post Installation Checks
(on page 91) to ensure that the installation is successful.