Cisco PowerKEY CableCARD Module 805 Guida All'Installazione
Chapter 3 Install the PCG Software
16
78-4017672-01 Rev E
Installing the PCG Operating System (Platform)
from CD
Complete the following steps to install the PCG Operating System (OS) Platform.
1 Press the DVD/CD eject button to open the drive.
2 Place the PCG OS Platform Installation CD into the drive tray and close the tray.
1 Press the DVD/CD eject button to open the drive.
2 Place the PCG OS Platform Installation CD into the drive tray and close the tray.
The server will boot from the CD. You will see a boot welcome screen and the
prompt boot:
prompt boot:
3 Type platform and press Enter. The installation will continue unattended and
takes about ten minutes to complete. After installation, the server will eject the
CD and reboot. You will be returned to the prompt pcg login:
Important: You may be presented with a warning screen that displays the
following message:
CD and reboot. You will be returned to the prompt pcg login:
Important: You may be presented with a warning screen that displays the
following message:
The partition table on device sda was unreadable ...
Would you like to initialize this drive, erasing ALL DATA?
Answer yes to
this prompt and proceed.
4 Did the pcg login: prompt appear, indicating that the installation was successful?
If yes, continue by installing the Installing the PCG Bootup Files (on page
17).
17).
If no, continue with step 5.
5 Did GRUB display on the screen for more than 10 minutes?
If yes, the installation may have failed while building the GRUB bootloader.
Go to Recover from a PCG Platform Installation Failure (on page 83).
Go to Recover from a PCG Platform Installation Failure (on page 83).
If no, contact Cisco Services.