Cisco Cisco D9824 Advanced Multi Decryption Receiver Guida All'Installazione
Configuring Transport Stream Information
OL-29015-01
221
Typical set up for Digital Program Mapping (DPM)
1 Verify that you are receiving a valid signal and that you have set up the channels
that you want to pass, drop, or map.
2 From the user interface of the D9824, choose Transport Stream > ASI Output or
MPEG over IP Output.
3 From the Output Mode drop-down list, choose Full DPM Control.
4 If necessary, from the Descrambled drop-down list, choose whether the program
4 If necessary, from the Descrambled drop-down list, choose whether the program
is to be scrambled or descrambled for downstream viewing or monitoring.
5 Click Apply.
6 Choose Transport Stream > Digital Program Mapping for ASI Output or
6 Choose Transport Stream > Digital Program Mapping for ASI Output or
MPEG over IP Output. The ASI or MPEGoIP Digital Program Mapping page is
displayed.
displayed.
7 In the DPM Program Entry Setup table, click Resynchronize All and click the
Resynchronize Program, PMT PID, ES List & ES PIDs radio button and click
OK. This copies the input services PIDs to the remapped output service PIDs.
OK. This copies the input services PIDs to the remapped output service PIDs.
8 In the DPM Program Entry Setup table, choose the PE containing the channel
you want to configure and click Edit. The DPM PE PID MAP window is
displayed.
displayed.
9 Click Add Row.
10 From the Action drop-down list, choose Pass, Drop, or Map.
11 Choose the input to output channel mapping from the Category drop-down list.
10 From the Action drop-down list, choose Pass, Drop, or Map.
11 Choose the input to output channel mapping from the Category drop-down list.
Video and PCR can be output on the same PID or different PIDs. If output on the
same PID, they will appear identical to the input.
same PID, they will appear identical to the input.
12 Click Save.
13 Click OK.
14 In the DPM General Setting area, choose the following parameters:
13 Click OK.
14 In the DPM General Setting area, choose the following parameters:
Setting
Parameter
Remapping Mode
Svc ID & PID
Duplication Method
Pkt Copy
Unreferenced Content
Drop
Service ID Output
Valid Ch/All Ch
PSI Table Output Option
Ctl By Table
PSI Regeneration Option
Always/As Needed
15 Click Table Options. The DPM Table Options window is displayed.
16 Set the following parameters:
16 Set the following parameters: