Cisco Cisco D9804 Multiple Transport Receiver Guida All'Installazione

 

78-4042990-01 Rev B 

127 

 

 

Proceed as follows to configure the backup and restore control: 
1  From the user interface of the D9804 MTR, click the System tab and then Backup 

Restore Setup icon from the sub-page. 

 

Note: You must have access to an FTP Server (e.g. WinFTP) on a network or a 
local PC before you can setup backup/restore controls.  

2  Type the File Name of the backup/restore file. You can enter up to 31 characters. 
3  Set the FTP Server IP Address of the FTP server used to store the 

backup/restore file. The address is up to 12 characters in length (e.g., 
171.300.100.200) and in the range from 0 to 255. 

4  Set the FTP port of the FTP server used to store the backup/restore file. You can 

enter a port number in the range of 1 to 65535. 

5  Set the FTP Username and Password to access the FTP server. 
6  Select the backup data sets (Backup Type) to be included in the backup/restore 

file. The following table lists the backup files and their descriptions: 

Standard 

Select Standard to save user settings to the backup file. 

Extended 

Select Extended to save user settings and tuning information to the 
backup file. 

Full 

Select Full to save user settings, tuning information, and factory 
defaults to the backup file. 

7  Click Backup to save the settings to a backup file. Click Restore to retrieve the 

last backed up file. 
While backup or restore is in progress, the operation status, file transfer 
percentage, and detailed status windows appear. 

8  Click on the “Click here...” link under the Action section to open the backup 

status page to check the status of the current operation.