Cisco Cisco D9804 Multiple Transport Receiver Guida All'Installazione
Steps using the Web Interface
78-4042990-01 Rev B
9
2 Set the following parameters.
Entry/Selection
Options
Input Enabled
Set to Yes to enable the input.
Inband Data
Set to Ignore to use local data.
Modulation System
DVB-S or DVB-S2. If set to DVB-S2, set FEC to Auto.
Frequency
Type in the downlink frequency (GHz).
FEC
If the FEC is unknown, leave it at "auto". It must be set to Auto if
DVB-S2 modulation is used.
DVB-S2 modulation is used.
LNB Voltage
The LNB Voltage options are 13, 18 and OFF.
LO frequency (GHz) LO (Local Oscillator) frequency in GHz.
Rolloff
Only required for DVB-S2.
IQ
Normal, Inverted, or Auto.
3 Click Save and then Apply Local to apply the saved settings to the receiver.
Setting up ASI Output Routing Parameters
Proceed as follows to set the ASI output parameters:
1 From the user interface of the D9804 MTR, click the Setup tab, and click ASI-1 to
1 From the user interface of the D9804 MTR, click the Setup tab, and click ASI-1 to
ASI-6 for each of the outputs. Any output can receive data from any one of the 4
RF inputs or from the ASI input.
RF inputs or from the ASI input.
2 Set the following parameters:
Entry/Selection
Options
Output Enabled
Set to Yes to enable the output.
Inband Data
Set to Ignore to use local data.
Input Source
Select the input source (RF1 to RF4, or ASI) for the output.
Format
Decombined - Decombines the transport according to the selected
CT ID (combined transport ID).
CT ID (combined transport ID).
Remux - The CT ID is remultiplexed when passed to the selected
output.
output.
Drop - Filters the input prior to sending; will allow all PIDs
except those entered.
except those entered.
Pass - Filters the input prior to sending; will only allow PIDs that
have been entered.
have been entered.
Raw - Passes the input directly to the output.
PCR Correction
Enable or Disable. Not used for Decombined or Remux streams
(see Format above).
(see Format above).