Cisco Cisco D9804 Multiple Transport Receiver Guida All'Installazione
Chapter 2 Introduction
16
78-4042990-01 Rev B
Control and Management Interfaces
Ethernet
The main control interface for the D9804 MTR is the 10/100 BaseT Ethernet interface.
You can set up and control the D9804 MTR via the Ethernet connection using SNMP
and a management system. The Web-based GUI may also be used for control and
monitoring purposes.
and a management system. The Web-based GUI may also be used for control and
monitoring purposes.
A MIB file is included in the delivery from Cisco for the D9804 MTR to support third
party SNMP managers. The D9804 MTR features an Ethernet management interface
which supports communication with the IBCC application. For information on the
Ethernet management interface, see Connecting the Ethernet Management Interface
(on page 23).
party SNMP managers. The D9804 MTR features an Ethernet management interface
which supports communication with the IBCC application. For information on the
Ethernet management interface, see Connecting the Ethernet Management Interface
(on page 23).
Front Panel Control
The front panel keypad and LCD is used to control the operating parameters of the
MTR.
MTR.
Note: The front panel door presently serves no function. It is reserved for future use.
The following drawing shows the front panel with its different sections.
Alarm Relay Interface
During operation the condition of the D9804 MTR can be monitored by seven relay
contact outputs, accessible from the Alarm connector on the rear panel of the D9804
MTR. Furthermore, the alarm status is signaled by an Alarm/Warning LED on the
front of the D9804 MTR and by messages sent via the management system.
contact outputs, accessible from the Alarm connector on the rear panel of the D9804
MTR. Furthermore, the alarm status is signaled by an Alarm/Warning LED on the
front of the D9804 MTR and by messages sent via the management system.