Cisco Cisco Compact EGC Segmentable Node A90200 Guida All'Installazione
Installation
2-3
Installing and Remove Optical Reverse Transmitter
To Install and Remove the Transmitter
Complete the following steps to install or remove the optical reverse transmitter to
the optical section.
1. Open the node housing.
2. Open the fiber clip on the metal cover and wire the fiber in the fiber guide.
3. Insert the optical reverse transmitter in the slot and ensure that the transmitter
the optical section.
1. Open the node housing.
2. Open the fiber clip on the metal cover and wire the fiber in the fiber guide.
3. Insert the optical reverse transmitter in the slot and ensure that the transmitter
is seated properly. (Where to insert the transmitter is described in the
instruction for the compact node)
instruction for the compact node)
4. Use a cross screwdriver to tighten the mounting screw.
5. Bind the fiber in the fiber tray.
6. Clean the tips of the fiber connectors.
7. Insert the fiber connector into the optical adapter.
6. Clean the tips of the fiber connectors.
7. Insert the fiber connector into the optical adapter.
a) If you don’t need remove the transmitter at this time, proceed to step 11.
b) If you need remove the transmitter at this time, proceed to step 9.
b) If you need remove the transmitter at this time, proceed to step 9.
8. Disconnect the fiber connecter from the optical adapter, and cover the fiber
connecter and optical adapter with dust caps immediately.
9. Use a cross screwdriver loosen the mounting screw to remove the transmitter,
and put the module in a proper place
10. Connect the power plug.
11. Close the node housing.
11. Close the node housing.
CAUTION:
Make sure enough space is reserved for installing the transmitter. Remove any
items both on the mainboard and on the lid if the node cannot be closed.
items both on the mainboard and on the lid if the node cannot be closed.