Cisco Headend System Release 2.5 Guida Utente

2-16 

Setting Up the TSBroadcaster 

4011043 Rev B 

This section provides instructions for configuring the delivery system parameters. 

By default, TSBroadcasters for OCAP systems are configured for modulation with 

the following parameters. 

699 MHz 

  SCTE Mode 1 (64 QAM) 

If your receiver relies on inband SI from the TSBroadcaster for tuning, configure the 

modulator and receiver to use these settings and tune your receiver. 
If your receiver relies on out-of-band (OOB) SI from a headend system for tuning or 

you cannot use the settings above, you need to change the TSBroadcaster settings. 

You will need to ensure that transport stream and service parameters are consistent 

between the TSBroadcaster and the transmission system (which may be re-

multiplexing and re-mapping the inband transport stream from TSBroadcaster). To 

do this through the TSBroadcaster client UI, see Chapter 3, Using the 

TSBroadcaster, for instructions on Create an OCAP Stream and on Create an OCAP 

Service. When you have entered parameters that are consistent with the headend 

settings, tune your receiver. 
When you tune your receiver, you should find a single transport stream containing 

two services. If you cannot find a signal when you tune your receiver, see Cannot 

Tune to Stream in Chapter 11, Troubleshooting.