Cisco Headend System Release 2.5 Guida All'Installazione
78-738190-01 Rev B
SR 2.5 and SR 3.5 Post Upgrade Procedures
5-25
Reset Modulators,
Continued
6.
Click File and then select Reset.
Result: A confirmation message appears.
Result: A confirmation message appears.
7.
Click Yes on the confirmation message.
Result: The modulator resets.
Result: The modulator resets.
8.
Repeat steps 5 through 7 for up to three additional modulators, and then go to
step 9.
Important: Never reset more than four modulators at once, or you may
Important: Never reset more than four modulators at once, or you may
overload the DNCS.
Note: In step 10, you will have the opportunity to reset additional
Note: In step 10, you will have the opportunity to reset additional
modulators.
9.
Wait a few minutes and then type ping [IP address] and press Enter to ping
each modulator you just reset.
Example: ping 172.16.4.4
Result: The ping command displays a message similar to Device is alive
Example: ping 172.16.4.4
Result: The ping command displays a message similar to Device is alive
when the modulator has been reset.
Note: It may take up to 5 minutes for each modulator to reset.
Note: It may take up to 5 minutes for each modulator to reset.
10.
Do you have additional modulators to reset?
•
•
If yes, repeat steps 5 through 9 as many times as necessary until all of your
modulators have been reset, and then go to step 11.
•
If no, go to step 11.
11.
Click File and then select Close to close the QAM List window.
12.
Did you record the Program Count and the Session Count for each modulator
not used for VOD, as specified in step 1?
•
•
If yes, repeat step 1 to verify that the Program Count and Session Count
totals match what you recorded before resetting the modulators, and then
go to Reset QPSK Modulators, next in this chapter.
Important: If the Program Count and Session Count totals do not match
Important: If the Program Count and Session Count totals do not match
what you recorded prior to resetting the modulators, contact Cisco Services.
•
If no, go to Reset QPSK Modulators, next in this chapter.