Cisco Headend System Release 2.5
Set Up the QAM
4004148 Rev C
121
4 Configure the INPUT Transport Stream ID field with the same value that you
recorded as the TSID on the Set Up MPEG Source window in a previous
procedure, Creating an MPEG Source (on page 117).
procedure, Creating an MPEG Source (on page 117).
5 Click the Connectivity tab.
6 In the Connect To area of the window, click the arrow to the right of each of the
6 In the Connect To area of the window, click the arrow to the right of each of the
following fields and set each field to none:
Device Type
Device Name
Card Type
Slot Number
Port Number
Note: The system requires that you first set these fields to none before you
change the configuration.
change the configuration.
7 Click Save.
Important! If the Save button is unavailable after completing step 7, close the Set
Up QAM window. Then, double-click the BFS QAM from the QAM List window
to gain access again to the Set Up QAM window.
Up QAM window. Then, double-click the BFS QAM from the QAM List window
to gain access again to the Set Up QAM window.