Cisco Headend System Release 2.7 Guida All'Installazione
Chapter 2 Configuring the PowerKEY DVB System
16
4017650 Rev C
Configure the SI-Server, D96xx Re-multiplexers,
and the DCM
and the DCM
Introduction
This section provides a high-level overview of the procedures for configuring the SI-
Server, D96xx re-multiplexers, and the DCM for the PowerKEY DVB System in SR
i4.2.2.
Server, D96xx re-multiplexers, and the DCM for the PowerKEY DVB System in SR
i4.2.2.
Configuring the SI-Server, D96xx Re-Multiplexers, and the DCM
1 On the SI-Server, access the ROSA Element Manager. For step-by-step
instructions, refer to the following manuals for instructions for using the SI-
Server and the ROSA Element Manager:
Server and the ROSA Element Manager:
SI-Server Complete SI Solution User Manual
ROSA Network Management System User's Guide
2 On the SI-Server, add all D96xx re-multiplexers to the ROSA database.
3 Configure the D96xx re-multiplexers.
3 Configure the D96xx re-multiplexers.
Important: If used in scrambling mode, enable all scrambling licenses.
Note: Refer to the Continuum DVP D9600 Advanced Headend Processor
Re-multiplexer and Transport Stream Processor Series Installation and Operation Guide
for additional information to configure the D96xx re-multiplexers.
Note: Refer to the Continuum DVP D9600 Advanced Headend Processor
Re-multiplexer and Transport Stream Processor Series Installation and Operation Guide
for additional information to configure the D96xx re-multiplexers.
4 Synchronize the time of day on the SI-Server using ROSA.
5 Pass services to the outputs of the D96xx re-multiplexers.
5 Pass services to the outputs of the D96xx re-multiplexers.
Important: Write down all of the program numbers on each D96xx output. You
will need these program numbers later when you create SI tables.
will need these program numbers later when you create SI tables.
6 Configure the D96xx re-multiplexers to generate the time offset table (TOT).
7 On the SI-Server, generate the service descriptor table ([SDT] actual and other),
7 On the SI-Server, generate the service descriptor table ([SDT] actual and other),
and distribute the SDT to the corresponding D96xx re-multiplexers.
8 On the SI-Server, generate the network information table (NIT) and distribute the
NIT to all D96xx re-multiplexers.
9 If applicable to your system, use the SI-Server to generate the bouquet
association table (BAT) and then distribute the BAT to all D96xx re-multiplexers.
Note: The BAT is a collection of services similar to a channel map.
Note: The BAT is a collection of services similar to a channel map.
10 On the SI-Server, set up the Electronic Preview Guide (EPG) scheduler and the
event information table (EIT) to generate the EIT present/following and
schedule tables for each D96xx re-multiplexer.
schedule tables for each D96xx re-multiplexer.