Cisco Headend System Release 2.5 Guida All'Installazione
Create a SAM Service
4019969 Rev B
43
3 Enter values in the following fields:
Service Name: The service name can be the same as the name used for the
short description. Read about the Short Description field before completing
this field.
Short Description: This field identifies how the service is to be launched.
Type one of the following descriptions in the Short Description field to
indicate how you want subscribers to launch the InView main menu of
InView service:
–
–
_KEYA: launches the InView main menu when the A key on the remote
control is pressed.
–
_KEYB : launches the InView main menu when the B key on the remote
control is pressed.
Note: The _KEYA and _KEYB are reserved system words that instruct
Note: The _KEYA and _KEYB are reserved system words that instruct
SARA to activate the application when the subscriber presses the A or B
key on the remote control.
–
The short description can be anything (for example, InVue) if InView
services are to be accessible from the Services Portal.
–
The short description can be anything (for example, INVOD) if an InView
service is to be accessible from a specific channel.
4 In the Long Description field, type a string description of the service being
offered.
5 In the Application URL field, type the following URL:
bfs://InView/InView.ptv; EID=[rep of EID]; parameter=String; trans=[t or f];
version=[rep of Version]
Notes:
Notes:
Replace [rep of EID] in this entry with the decimal representation of the
hexadecimal InView EID that you recorded in step 3 of the Determining the
Package EID (on page 41), earlier in this chapter.
Replace trans=[t or f] with one on the following trans parameter values to
determine whether channel changes will exit the application:
–
–
trans=t: causes the application to exit when a channel change occurs.
–
trans=f: allows the TV channel to be changed while keeping the
application active.
Note: The trans parameter only works with overlay services (the InView
Note: The trans parameter only works with overlay services (the InView
service is launched on top of a Channel Based InView service). The
channel-based application will not respond to this parameter.
Replace [rep of Version] in this entry with the version of the InView
application.
6 In the Logo field, type 0 to indicate that no logo is needed.
7 In the Parameter section, select String.
7 In the Parameter section, select String.