Cisco Headend System Release 2.7 Guida All'Installazione
Logging on to the RNCS Servers
4022447 Rev B
11
Logging on to the RNCS Servers
These instructions are to be completed at the remote location and assume that the
Sun Fire V240 and V245 servers have not yet been configured to serve as a remote
server in the RNCS design.
Sun Fire V240 and V245 servers have not yet been configured to serve as a remote
server in the RNCS design.
Complete the following steps to log on to an RNCS server.
1 Connect a laptop computer to the serial network management port of the RNCS
1 Connect a laptop computer to the serial network management port of the RNCS
server.
2 Start the HyperTerminal application on the laptop and configure the application
with the following parameters:
Baud rate—9600
Data bits—8
Parity—none
Stop bit—1
Flow control—no
Note: The HyperTerminal application allows one computer to communicate with
another computer.
another computer.
3 If necessary, power on the RNCS server.
4 Type #. and press Enter. One of the following results occurs:
4 Type #. and press Enter. One of the following results occurs:
The Login prompt appears.
The sc> prompt appears.
5 Did the Login prompt appear after you completed step 4?
If yes, go to step 6.
If no (the sc> prompt appeared), go to step 7.
6 If the Login prompt appeared after completing step 4, complete the following
steps.
a Type admin and press Enter.
b Type the password (changeme) and press Enter. The sc> prompt appears.
a Type admin and press Enter.
b Type the password (changeme) and press Enter. The sc> prompt appears.
7 Type break and press Enter. The system interrupts the boot process of the RNCS
server.
8 Type console -f and press Enter. A message appears that instructs you to type #.
to return to the ALOM port.
9 Press Enter again.
Results:
Control transfers to the console of the RNCS server (rather than the ALOM
port).
port).
The ok prompt should appear.