Cisco Headend System Release 2.5 Guida Utente
Chapter 1 Staging Preparation
10
4025012 Rev B
9 Click Save. The new group appears in the list of group descriptions on the
DHCT Groups tab.
Note: The Tuning Adapter should be connected to the network within 2 hours of
Note: The Tuning Adapter should be connected to the network within 2 hours of
creating or adding it to a test group. If the device is not connected within 2 hours,
then the device does not receive a group assignment until the DNCS database
cycles through all in-service devices at a rate of approximately one device per
second. Depending on the number of devices in your system, this process could
take a significant amount of time.
10 Confirm that the Tuning Adapter was successfully placed into the test group by
displaying the Tuning Adapter diagnostic screens on the UDCP and looking at
the Group ID field. This group ID should match the Group ID field displayed on
the Set Up a DHCT Group window on the DNCS.
Note: The Group ID on the Tuning Adapter is in hexadecimal format. The Group
Note: The Group ID on the Tuning Adapter is in hexadecimal format. The Group
ID on the DNCS is in decimal format. You might need to convert the Group ID to
verify this step.
11 Do the Group ID values on the diagnostic screen and DNCS match?
If yes, go to Staging the Tuning Adapter (on page 13)
If no, contact Cisco Services
Add the Tuning Adapters to Existing CVT Download Groups
If your download group already exists, follow these steps to add the Tuning
Adapters to the group. If your download group does not already exist, follow the
steps in Create CVT Download Groups (on page 9).
Adding Tuning Adapters to Existing CVT Download Groups
1 On the DNCS Administrative Console, select the DNCS tab.
2 Select the Home Element Provisioning tab.
3 Click Image. The Image List window opens.
4 Click the DHCT Groups tab. The DHCT Groups tab opens.
1 On the DNCS Administrative Console, select the DNCS tab.
2 Select the Home Element Provisioning tab.
3 Click Image. The Image List window opens.
4 Click the DHCT Groups tab. The DHCT Groups tab opens.