Cisco Cisco Tidal Enterprise Scheduler 6.2 Guida All'Installazione
7-9
Cisco Tidal Enterprise Scheduler Installation Guide
OL-32249-01
Chapter 7 Installing Fault Tolerance
Installing Fault Tolerance for Unix
Starting the Fault Monitor
To start the Fault Monitor, use the following command:
Step 1
From the Windows Start menu, and choose Programs > Tidal Software > Tidal Service Manager to
display the Tidal Services Manager.
display the Tidal Services Manager.
Step 2
From the Service list, choose SchedulerFaultMon.
Step 3
Click Start.
Stopping the Fault Monitor
To stop the Fault Monitor, use the following command:
Step 1
CFrom the Windows Start menu, and choose Programs > Tidal Software > Tidal Service Manager to
display the Tidal Services Manager.
display the Tidal Services Manager.
Step 2
From the Service list, choose SchedulerFaultMon.
Step 3
Click Stop.
Checking the Fault Monitor Status
To check the operation status of the Fault Monitor, use the following command:
Step 1
On the Fault Monitor machine, click the Windows Start button and choose Programs > Tidal Software
> Tidal Service Manager to display the Tidal Service Manager.
> Tidal Service Manager to display the Tidal Service Manager.
Step 2
From the Service list, select Fault Monitor. At the bottom of the Tidal Service Manager, the status of
the selected service displays.
the selected service displays.
Installing Fault Tolerance for Unix
Installing fault tolerance on a network means adding another Master to shadow an existing Master. The
first Master becomes the Primary Master in TES while the second Master is referred to as the Backup
Master. A network component that monitors the operation of the two Masters called the Fault Monitor
is installed on a third machine.
first Master becomes the Primary Master in TES while the second Master is referred to as the Backup
Master. A network component that monitors the operation of the two Masters called the Fault Monitor
is installed on a third machine.
While there is a Fault Monitor console for the Windows platform that displays activity messages about
Fault Monitor components, there is no such Fault Monitor console for the Unix platform. The activity
messages from the Fault Monitor can be displayed and controlled from the Fault Monitor pane in the
TES Web Client. For more information, refer to the
Fault Monitor components, there is no such Fault Monitor console for the Unix platform. The activity
messages from the Fault Monitor can be displayed and controlled from the Fault Monitor pane in the
TES Web Client. For more information, refer to the
.
The fault tolerance setup consists of steps which must be performed in order. The procedures for each
step are covered in these sections:
step are covered in these sections:
•
•
•
•